Troubleshooting - HoMedics Cool & Warm Mist Manual De Instrucciones E Información De Garantía

Troubleshooting

PROBLEM POSSIBLE CAUSE
No Power/ • Unit is not plugged in
No Mist from Spout
• No power at oulet
• Low water level
• Room humidity at desired
humidity setting
Peculiar Odor • If new unit
• If unit is in use, the odor
may be a dirty tank or old
tank water
Excessive Noise • Unit is not level
• Low water level
White Dust Accumulation • Hard water used
• Demineralization Cartridge
needs replacement
FCC DISCLAIMER
NOTE: This product has been tested and complies with the requirements for Federal
Communication Commission, Part 18. Although this product is tested and complies with FCC,
it may interfere with other devices. If this product is found to interfere with another device,
separate the other device and this product. Conduct only the user maintenance found in this
instruction manual. Other maintenance and servicing may cause harmful interference and
can void the required FCC compliance.
SOLUTION
• Plug unit in
• Press the POWER button
once to turn the power on
• Check circuits and fuses or
try a different outlet
• Refill tank with water
• Increase room humidity
setting or change
humidistat setting to "CO"
(Continuous ON)
• Open the water tank cap
and keep it in a shady and
cool place for 12 hours
• Empty the old water,
clean the tank and fill
with clean water
• Place unit on a flat,
even surface
• Check the water level. Refill
the tank if the water is low
• Use distilled water and a
Demineralization Cartridge
• Replace Demineralization
Cartridge
1 0 1 1