Accessories; Safety Card; Coded Keypad; Badge Reader - tormatic DTS T1E Instrucciones Para La Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

with a start pulse and if it is already moving.
Opening safety device input – When SWITCH 8 is in the ON position: N.C. contact.
This is a safety device input which is enabled during closing and opening. When the
input is enabled, the gates are stopped immediately. When the input is disabled, the
gates start to move in the same direction as before after a delay of 1 second. This
function can be used to protect the areas where crushing may occur.
Closing input - Input which is only enabled when Dead Man mode is selected. It closes
the automation when the close push-button is pressed and held down.
NOTE - The selection of one function disables the other functions.
Electric lock output - 12 VAC output with maximum load of 15W, which commands
the electric lock for approximately 1.5 seconds during opening.
Warning light output - 24VDC output with maximum load of 3W, which commands the
gate state warning light. Light OFF: gate closed. Steady light: gate open or opening.
Flashing light: gate closing.
Flashing light output - 24 V output which commands the fl ashing light.
This output commands the fl ashing light with a pulsating power supply with frequency
of 1 Hz: the light comes ON for 0.5 seconds and OFF for 0.5 sec. If pre-fl ashing is
enabled, this output is enabled 3 seconds before the command to move the gates
(opening and closing).
NOTE - Only use TORMATIC Series LED fl ashing lights or the output may be broken:
this will cause the entire system to malfunction.
Motor output - The device has two outputs for independent motors. The output for
motor 1 is used to select the gate closing delay using the SWITCH; the output for motor
2 is used to command a fi xed opening delay of 1.5 seconds. If the single wing input
is used, only the wing connected to the output for motor 1 will start. If a start pulse is
given during this stage, the second wing will start.
NOTE - If these devices are used in automations with only one wing, the motor MUST
be connected to the output for motor 1.
ENGLISH

5. ACCESSORIES

NOTE - Please refer to tht specifi c accessory instruction manual.
5.1 SAFETY CARD (for electromechanical motors TORMATIC-230 VAC)
Accessory card for activating the anti-crush function for both motors. Functioning is
factory-set and shall not be adjusted.
When the anti-crush function is activated, the led corresponding to the involved motor
lights up on the card.

5.2 CODED KEYPAD

It is possible to install a coded keypad by connecting the decoding card to the K3
connector.

5.3 BADGE READER

It is possible to fi t a badge reader by connecting the decoding card to the K3 con-
nector.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido