Troubleshooting - STEINEL PROFESSIONAL HBS 200-WL Manual De Instrucciones

Setup & Commissioning
HBS 300-WL Coverage
The HBS 300-WL contains three pyroelectric
sensors to detect occupancy. At an installation
height of 8 to 45 feet, maximum reach is 22 feet
radial and 60 feet tangential.
Coverage may vary depending on mounting
height and environmental conditions.
HBS 200-WL Coverage
The HBS 200-WL contains two pyroelectric
sensors to detect occupancy and has an aisle
way coverage of up to 100 feet when mounted
at 40 ft.
In addition, the view of the HBS 200-WL can be
rotated 90 degrees. To do this, remove the four
screws securing the front cover and gasket to
the back box, remove the sensor housing from
the back box by pressing the tabs on either side
of the sensor.
Coverage may vary depending on mounting
height and environmental conditions.
10ft/3m
20ft/6.1m
30ft/9.1m
40ft/12.2m
50ft 40ft 35ft 35ft
15.2m12.2m 10.7m 10.7m
22ft 22ft
6.7m 6.7m
10ft/3m
20ft/6.1m
30ft/9.1m
40ft/12.2m
50ft 50ft
15.2m 15.2m
53ft 53ft
16.2m 16.2m
radial
tangential
- 8 -

Troubleshooting

Malfunction
No power at the sensor
40ft 50ft
12.2m 15.2m
Lights do not switch ON
Lights do not switch OFF
Lights keep switching
ON/OFF
Lights switch ON without
obvious movement
Warranty
5 Jahre
STEINEL America warrants its products against
defects in material or workmanship for
a period of fi ve years.
F
UNCTIONAL
5 Year 5 Year
W
ARRANTY
5 Ans
Cause Remedy
breaker has tripped;
light switch is in OFF position
short circuit
light level setting is in nighttime
mode during daytime operation
lamp burned out
power is OFF
detection zone not correctly adjusted
abundant heat from the fi xture is
within detection zone and keeps
lights on as a result of temperature
change
the fi xture is moving from
side to side
HVAC vent is causing air fl ow
to switch lights ON
5 Års
STEINEL will replace or repair the item provided
that it has not been altered or subjected to abuse,
accident, improper installation or improper use.
There are no obligations or liabilities on the part of
STEINEL for consequential damages arising out
5 Års
5 Letnia
of or in connection with the use or performance of
this product or other indirect damages with respect
to loss of property, revenue, or profi t, or cost of
removal, installation or reinstallation.
5 Vuoden
- 9 -
reset breaker, turn light switch
to ON position, check wiring
with voltage tester
check for proper wiring
connections
adjust light level setting
replace lamp
turn power on at circuit breaker
readjust
mount sensor below fi xture
(EM1 extender module)
stabilize the fi xture
redirect air fl ow away from the
sensor
5 Ле
5 Γοди
5 Ani