Snapper ST48 Manual Del Propietário página 14

ASSEMBLY
ATTACH THE AUXILIARY HANDLE (See Figures 5.1 and 5.2)
1. Loosen the two screws (1) in the handle with a philips screwdriver (not
included) and remove the screws from the handle.
2. Attach the auxiliary handle (2) and lower clamp (3) on the shaft.
3. Adjust handle up or down, if necessary, to desired operating position.
4. Insert and tighten the two screws so that the handle cannot be rotated on
the shaft.
1
2
14
Fig. 5.1
3
Fig. 5.2