Section 5. Programming Cleaning Cycles; Displaying Current Day And Time; Changing Day And Time; Setting Cleaning Cycles - Polaris 9400 Sport 4WD El Manual Del Propietario

Page 12
Section 5. Programming
Cleaning Cycles
You can program up to three (3) preset cleaning cycles
to run the cleaner on a specific day and time when you
are away from the pool
NOTE: You cannot change programming or display
current day and time during a cleaning cycle.
5.1

Displaying Current Day and Time

Press to display current day and time.
Current day and time is displayed for 5 seconds.
5.2

Changing Day and Time

1. Press and hold
Current day setting flashes.
2. Press or
through seven (7) days and display desired day.
3. Press to select.
Current hour setting flashes.
4. Press or
through 24 hours and display desired hour
setting.
for three (3) seconds.
buttons to cycle
buttons to cycle
NOTE: Control unit is set to display time in 24-hour clock
format. Time setting will cycle through 1-24.
5. Press to select.
Current minutes setting flashes.
6. Press or
through 1-59 minutes and display desired
minutes setting.
7. Press to select.
The display flashes for you to begin
programming a cleaning cycle if necessary (see
section 5.3 Setting Cleaning Cycles).
8. Press or
as current and exit the menu.
9. Press to display current day and time
setting and verify the time you set is correct.
5.3

Setting Cleaning Cycles

You can program up to seven cleaning cycles. After
completion of the seventh cycle, the PROG LED
turns off. You may program cleaning for either seven
consecutive cycles or the same cycle repeated over
several weeks (e.g., every Wednesday and Saturday for
three weeks).
1. Press
pool or bottom plus sides of pool.
2. Press to view each of the currrent
programmed cleaning cycles. Cycle day and
time is displayed for three seconds.
3. When the cleaning cycle you want to change is
displayed, press and hold
buttons to cycle
to set displayed time
to select either bottom of
.