Connecting To Power Source; Section 4. Operation; Submerging The Cleaner - Polaris 9400 Sport 4WD El Manual Del Propietario

Page 8
3.4

Connecting to Power Source

WARNiNg
Failure to comply with the following warnings can
result in permanent injury, electrocution or drowning.
PREVENT ELECTRiCAL ShOCk
• U.S.: Per NEC requirements, keep the control
®
unit at least five (5) ft. (1.5 m) from the edge of the
pool. CANADA: Per CEC™ requirements, keep
the control unit at least three (3) m (10 ft.) from the
edge of the pool.
• Only connect the control unit to a receptacle
protected by a ground fault circuit interrupter
(GFCI). Contact a certified electrician if you cannot
verify that the receptacle is protected by a GFCI.
• Do not use an extension cord to connect the control
unit.
• Do not allow anyone to swim while the cleaner is in
the pool.
• The control unit is water-resistant, not waterproof.
In order to prevent electrocution, never submerge
the control unit or leave exposed to inclement
weather.
1. Unscrew the protective cap for the power cable
from the side of the control unit by turning
counter-clockwise (Figure 11).
Figure 11. Remove Protective Cap
2. Insert the end of the floating power cable into
the control unit and turn clockwise to tighten.
Do not overtighten (Figure 12).
Figure 12. Connect Power Cable
The control unit is equipped with an automatic shut
off feature to prevent overheating if operated in direct
sunlight for an extended period of time.

Section 4. Operation

4.1

Submerging the Cleaner

1. Submerge the cleaner in the pool and remove
any air trapped inside by keeping the unit
vertical (Figure 13).
1
Figure 13. Submerge the Cleaner Vertically