Starting The Cleaner; Important; Starting The Cleaning Cycle - Polaris 9400 Sport 4WD El Manual Del Propietario

2. Ensure the unit sinks to the bottom of the pool
and does not float (Figure 14).
2
Figure 14. Cleaner Sinking to the Bottom of the
Pool
3. Spread out the floating cable over the pool,
ensuring there are no kinks or coils in the cable
(Figure 15).
Figure 15. Spread Floating Cable Over the Pool
4.2

Starting the Cleaner

CAUTiON
To prevent damage to the cleaner, be sure to adhere
to the following guidelines:
• Remove the cleaner from the pool after the
cleaning cycle is completed and store on the caddy
out of direct sunlight or inclement weather.
• Never lift the cleaner out of the pool by the floating
cable. Always use the lift feature to remove cleaner
from the pool.
• Take additional care when lifting the cleaner out of
the pool. It becomes heavier when filled with water.
• Always remove the cleaner from pool when super
chlorinating or adding acid.
• Do not handle cleaner while it is in operation.

iMPORTANT

• Always make sure the cleaner head is fully
submerged before you begin operation.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a
permanent basis.
• At the end of each cycle, remove the cleaner from
the pool. Start at the cleaner head and untangle
any coils in the cable before storing the cleaner.
Page 9