Bosch 4405 Instrucciones De Funcionamiento Y Seguridad página 29

Saw Operations
Crown Molding Laying Flat on Table
Follow these instructions for cutting crown
molding:
1. Set the bevel and miter angles using Chart 1
below. Tighten the miter lock knob and the
bevel lock handle (Figure 33).
2. Position molding on saw table. Use the chart
below for correct position. Clamp workpiece in
place using the quick clamp.
NOTE: ALWAYS TAKE A TEST CUT USING
SCRAP TO CONFIRM CORRECT ANGLES.
Workpiece
Clamp
33.9 ° Bevel
Use clamping position that does not
interfere with operation. Before
switching on, lower head assembly to make sure
clamp clears guard and head assembly.
3. Follow procedures for either chop cut or slide cut
(see page 24).
4. Wait until blade comes to a complete stop
before returning head assembly to the raised
position and/or removing workpiece.
31.6 ° Miter
Figure 33. Crown Molding Laying Flat
Crown
Molding
CROWN MOLDING CUTS - CUTTING METHOD #1 - FLAT ON TABLE
MAX. SIZE: 10-1/4 ''
52 ° CEILING
E
N 38 °
C
E W
L
TABLE L
ANGLES OF U.S.
STANDARD MOLDING
INSIDE OUTSIDE
CORNER CORNER
TYPE MITER BEVEL TYPE MITER BEVEL
OF (TABLE) (TILT) OF (TABLE) (TILT)
CUT SETTNING SETTING CUT SETTNING SETTING
OUTSIDE CORNER
INSIDE CORNER
RIGHT
LEFT SIDE _) _ 31.6°_ 33.9 °
PLACE TOP EDGE OF
MOLDING AGAINST FENCE - SAVE LEFT END OF CUT
LEFT
RIGHT SlOE O _
31.6°=_ 33.9°
PLACE BOTTOM EDGE OF
MOLDING AGAINST FENCE - SAVE LEFT END OF CUT
LEFT SIDE 0
RIGHT
31.6 ° _
33.9 °
PLACE BOTTOM EDGE OF
MOLDING AGAINST FENCE - SAVE RIGHT END OF CUT
LEFT
RIGHT SIDE O _ 31.6°_ 33.9 °
PLACE TOP EDGE OF
MOLDING AGAINST FENCE - SAVE RIGHT END OF CUT
29.