Cutting Base Molding; Cutting Crown Molding - Bosch 4405 Instrucciones De Funcionamiento Y Seguridad

Saw Operations
Cutting Base Molding
• 3 1/2" or smaller base molding can be cut vertical
against fence. All base molding can be cut flat on
the table, up to a maximum width of 12".
• Follow the table for helpful hints on cutting
base molding.
• Cutting base molding can be done either as a
chop cut or a slide cut depending on the width of
the workpiece.
BASE MOLDING CUTTING INSTRUCTIONS
SE-I-rlNGS
/
INSTRUCTIONS
Bevel Angle
Molding position
Inside
corner of wall
i
I
I
Outside
Vertical Position
Back of molding is
against the fence
o
Right Side
Horizontal Position
Back of molding is flat
on the table
Miter Angle
Left Side
Right at 45 °
Left Side
45 °
Left at 45 °
o
Right Side
0 o
Molding Bottom Bottom Top against Bottom
position against table against table fence against fence
Finished
side
Keep left
side of cut
Keep right
side of cut
Keep left
side of cut
Left at 45 °
Right at 45 °
o
Miter Angle
Keep left
side of cut
o
corner of wall
, Molding Bottom Bottom Bottom against Top against
I
position against table against table fence fence
Finished Keep left Keep right Keep right Keep right
side side of cut side of cut side of cut side of cut
Cutting Crown Molding
Crown molding must becut exactly to fit properly.
There are two ways to cut crown molding:
flat on table or angled to table and fence.
Your miter saw has special miter detents of
31.6 ° left and right and a bevel detent of 33.9 °
for cutting crown molding flat on the table.
These special detents angles have been
designed into your compound miter saw for the
standard crown molding used in the United
States with the following angles:
52 ° between the back of the molding and the
top flat surface that fits against the wall.
38 ° between the back of the molding and the
bottom flat surface that fits against the wall.
NOTE: These detents cannot be used with 45 ° crown
molding.
Even though these angles are standards, most
rooms do not have angles of exactly 90 °, there-
fore, you will need to fine tune your settings
using the detent override.
Cutting crown molding flat on the table can be
done either as a chop cut or a slide cut depend-
ing on the width of the workpiece.
28.