Dremel 800 Instrucciones De Funcionamiento/Seguridad página 18

DM 2610919778 8-03 8/4/03
Cutting Wheels
These thin discs of emery or fiberglass are used for
slicing, cutting off and similar operations. Use them for
cutting off frozen bolt heads and nuts, or to reslot a
screw head which has become so damaged that the
screwdriver won't work in it. Fine for cutting BX cable,
small rods, tubing, cable and cutting rectangular holes
in sheet metal.
Drywall Cutting Bit
Gives you fast, clean cuts in drywall.
Mandrel No. 401 is used with the felt polishing tip and wheels. Thread the tip on to the screw carefully. The
felt tip must thread down straight on the screw Mandrel, and be turned all the way to the collar.
Mandrel No. 402 has a small screw at its tip, and is used with emery cutting wheels and sanding discs. Higher
speeds, usually maximum, are best for most work, including cutting steel. Which is shown here.
4:06 PM Page 18
Tile Cutting Bit
Cuts ceramic wall tile, cement board, and plaster.
Spiral Cutting Bit
Cuts through all types of wood and wood composites.
High Speed Router Bits
For routing, inlaying, and mortising in wood and other
soft materials.
attachment and No. 231 Shaper/Router table.
Page 18
Use with Dremel No. 330 Router