Controls; Operation; Enclosure Door; When Calling For Assistance - Briggs & Stratton Dual 200 Amp Manual De Instrucciones

Controls

Other than a Manual Override lever, there are no operator controls
because this is an automatic transfer switch. The manual override
is to be used only by licensed professionals. Information on handle
use can be obtained by calling Technical Service at 800-743-4115.

Operation

To select automatic transfer operation, do the following:
1. In the transfer switch, set both utility disconnect circuit
breakers
to ON position.
2. In the transfer switch, set generator disconnect circuit breaker
to ON position.
3. Install 15 Amp fuse in generator's control panel.
4. Set generator's circuit breaker to ON position.
5. Set generator's system switch to AUTO position.
The system will now be in automatic operation mode.
When the generator is providing power to the transfer switch, the
control module is constantly monitoring generator power. If the air
conditioner is called to run, and there is sufficient generator power
available, the controller will close contacts "A-A" to air conditioner
contactor. Contacts "B B" will open before contacts A-A close. If
loads are too great for the generator, contacts A-A and/or B-B will
open. When air conditioning is not needed, A-A will open. If enough
power is available, B-B will close.
16

Enclosure Door

To open the transfer switch door, remove the two exterior thumb
screws (A) and carefully lift off door.
To close and secure the door, push door closed against enclosure.
While in this position, the door can rest on the tab (B) at the
bottom of the enclosure. Reinstall both thumb screws to finger
tight. Enclosure door MUST be closed and secured at all times
except when system is being serviced.
A
B

When Calling for Assistance

You must have the Model Number and Serial Number from each
transfer switch or remote module ID label at hand if it is necessary
to contact a local service center regarding service or repair. Obtain
this information from the unit ID labels located on or inside device.
For convenience, record the information on the inside front cover of
this manual.
To contact Briggs & Stratton call 800-743-4115, between 8:00 AM
and 5:00 PM CT.
BRIGGSandSTRATTON.COM