Uline H -7033 Manual De Instrucciones página 5

OPERATING ISSUE
Desk does not go up or down.
The handset illuminates when
any button is pressed.
Desk does not go up or
down. The handset does not
illuminate when any button is
pressed.
Desk is unusually noisy.
Columns do not go up evenly.
Desk does not reset or
ER2 ER3
or
handset.
OH
displayed on handset.
If the troubleshooting section does not resolve your problem, contact Uline Customer
Service at 1-800-295-5510.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 5 OF 15
TROUBLESHOOTING
RECOMMENDATIONS
Unplug the power cord for 20 seconds, plug back in
and follow the initialization process to reset desk.
If initialization does not work, press and hold the
setting button until "SET" is displayed on handset. Then,
while still pressing setting button, press the fourth preset
position button "IV" until "rSt" is displayed on handset.
Press and hold down button until the desk reaches its
lowest height.
If problem persists, switch motor cables at control box
and attempt another reset.
Check all connections.
Make sure the power cord is plugged into the control
box and a power outlet.
Reset desk when the handset illuminates.
If the problem persists, switch motor cables at control
box and attempt another reset.
The desk has 2-stage legs that produce more noise
when one leg extends into the other.
To reduce noise, apply silicon lubricant to legs.
Unplug the power cord for 20 seconds, plug back in,
and follow the initialization process to reset desk.
If problem persists, switch motor cables at control box
and attempt another reset.
ER1
, Unplug the power cord for 20 seconds, plug back in
and follow the initialization process to reset desk.
displayed on
If problems persist, switch motor cables at control box
and attempt another reset.
Desk is overheated. Stop adjusting desk height for
20 minutes to let desk cool down.
1-800-295-5510
uline.com
0720 IH-7033