Quick SBC NRG Serie Manual De Instalacion Y Uso página 11

OPENING OF THE BATTERY CHARGER BY UNAUTHORISED PERSONNEL MAKES THE WARRANTY VOID.
THE PACKAGE CONTAINS: battery charger - conditions of warranty - user's manual - cable terminals (to be used for
connection to the output terminals).
EQUIPMENT NECESSARY FOR INSTALLATION
Use the batteries and cables on the output terminals as specified in the following table:
MODEL
Battery voltage
Battery capacity
Minimum output cable size
Number of battery cells
The cables connected to the output terminals have a maximum length of 4 metres.
WARNING: the battery charger must be used only with rechargeable lead/liquid electrolytic batteries (open or
sealed), gel, AGM.
WARNING: the battery charger can not be used to recharge non rechargeable batteries.
INSTALLATION SITE
Install the battery charger as close as possible to the
batteries in a dry and airy spot, to allow the correct
operation of the device at full power.
The battery charger can be installed in a horizontal or
vertical position with cables coming out in the downward
position.
The battery charger must be fixed to the support surface
with screws strong enough to support its weight, paying
attention that they do not weaken or cause cracks to
the boat structure.
The vertical position is recommended because the natu-
ral convection of heat helps to cool the equipment.
The perimeter of the battery charger (except the base)
must be kept at a distance from walls or objects by a
minimum of 5 cm.
SBC MINI LOW NRG - REV001B
CHARACTERISTICS AND INSTALLATION
SBC 140 NRG FR SBC 250 NRG FR
12 V
55 ÷ 120 Ah 110 ÷ 250 Ah
6 mm 2
6
SBC 300 NRG FR
12 V 12 V
140 ÷ 300 Ah
10 mm 2 10 mm
6
5 cm
SBC 365 NRG FR
24 V
65 ÷ 150 Ah
2 6 mm
6 12
5 cm
5 cm
GB
2
5 cm
11