Pilot Light; Power Switch - Peavey Windsor Studio Manual De Instrucciones

Front Panel
Reverb -
9
Controls the amount of reverberation that is mixed into the signal path.

Pilot Light -

10
Illuminates when AC power is being supplied to the amplifier.
Standby Switch -
11
Placing this switch in the "STANDBY" position will effectively shut the amplifier off while keeping
all heater and bias supplies active and ready to go. Leave this switch in the "STANDBY" position for
a minimum of one (1) minute after initially engaging the POWER SWITCH (12). This is also a useful
feature, since much tube wear comes from the heating and cooling of the actual tube. Leaving the unit
in "STANDBY", for short durations, allows the tubes to remain at their optimal operating temperature
while you are not playing. For extended periods, it is best to disengage both the STANDBY and POWER
switches.

Power Switch -

12
To apply power to the amplifier, flip this switch to the "ON" position. The red PILOT LIGHT (10) will
illuminate, indicating that AC power is being supplied.
WARNING
THE ON/OFF SWITCH IN THIS APPARATUS
DOES NOT BREAK BOTH SIDES OF THE MAINS.
HAZARDOUS ENERGY MAY BE PRESENT INSIDE
THE ENCLOSURE WHEN THE POWER SWITCH IS
IN THE OFF POSITION.
9
9
10 11 12