Setting The Clock And Delay Brew Time; Preparing For Use; Brewing Coffee Now - Oster BVST-JBX Serie Guia Del Usuario

HOW TO

Setting the ClOCk and delay Brew tiMe

On programmable models only
To Set the Clock:
1 Plug the power cord into a standard electrical
outlet.
2 Press the PROG button and the word CLOCK
appears. Press and hold the TIME button until you
reach the current time. The AM/PM indicator will light on the left of the display.
NOTE: Holding TIME for 3 seconds will speed the time up. Holding for 10 seconds will speed
it up again.
The clock is now set!
To Set the Delay Brew Time:
After setting the clock, simply press the PROG button twice (TIMER appears) (Figure 1),
and set the brew time by pressing and holding the TIME button. The AM/PM indicator
will light up on the clock display.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle, see the "Brewing Coffee Later" section.
NOTE: After about 10 seconds normal clock time will appear. To check the programmed
time, push the PROGRAM button until you see TIMER on the display. The display will show
the time you have programmed the coffee to brew.

PreParing FOr USe

Selecting and Measuring Ground Coffee
For best results, use a level tablespoon for ground coffee measurement. Make sure you use
medium grind coffee for a perfect brew.
Suggested Coffee Measuring Chart
To Brew
12 Cups
10 Cups
8 Cups
6 Cups
4 Cups
2 Cups
1 level tablespoon (tbsp) - 5 gr./0.17 oc/ 15ml
1 cup = 5 fl. oz. of brewed coffee
Use more or less coffee to suit your taste
www.oster.com
6
Figure 1
Ground Coffee
12 tbsp.
10 tbsp.
8 tbsp.
6 tbsp.
4 tbsp.
2 tbsp.
Adding Water and Ground Coffee
1 Lift and open the filter basket lid. For your convenience,
you can lift out the removable filter basket.
2 Place a 10–12 cup paper cone-style filter or a permanent
filter into the removable filter basket. (Figure 2)
NOTE: If using paper filters, it is important that the sides of
the filter fit flush against the side of the filter basket. If filter
collapse occurs, dampen the filter before placing in the filter
basket and adding ground coffee and water.
3 Add the desired amount of coffee and gently shake to
level the coffee. See the Suggested Coffee Measurement Chart.
4 Be sure the filter is properly centered and all the way down in the filter basket.
5 Fill the decanter with cold, fresh water to the desired capacity
(1 cup equals 5 ounces). For easy and accurate filling, the water markings on the
glass decanter show the amount of water needed to make the corresponding
desired number of cups. The amount of coffee brewed will always be slightly less
than the amount of water poured in the water reservoir. This is due to the minimum
absorption of water by the coffee grounds as well as steam.
6 Pour the water into the water reservoir. Do not fill past the "MAX line" or water will
flow out of the overfill hole in the back of the water reservoir. Close the lid and place
the empty decanter onto the warming plate.
NOTE: Make sure the decanter is fully placed on the warming plate or the water and the
grounds will overflow from the filter basket. An overflow may cause personal injury or
damage to property.
CAUTION! To reduce the risk of damaging the decanter and/or the risk of personal injury,
do not add cold water to the decanter if the decanter is already hot. Allow the decanter to
cool before using.

Brewing COFFee nOw

1
After completing the steps in the "Adding Water and Coffee" section and with the
decanter and the filter basket securely in place.
2
Press the AUTO/ON/OFF Button to begin the brewing
cycle. The red indicator light will turn on to signal
that the coffeemaker is brewing. When the brewing
cycle is complete, the coffeemaker switches over to
the warming mode. Your coffeemaker will keep your
coffee hot for 2 hours, then automatically shut off.
While the coffee is brewing, the Pause 'n Serve feature
allows you to sneak a cup of coffee from the decanter.
Replace the decanter on the warming plate within
30 seconds to prevent overflow and possible injury.
To turn the coffeemaker off, push the AUTO/ON/OFF
button until the light goes off. (fig 3)
3
To enjoy a more full flavored cup of coffee, press the
STRONG BREW button once. The STRONG BREW blue
light will turn on. The coffeemaker will remain in
the STRONG BREW you have selected until you change it back to REGULAR strength by
pressing the STRONG BREW button or until you unplug the machine (figure 4).
www.oster.com
Figure 2
Figure 3
Figure 4
7