Double Din Radio Provision; Stacked Iso Radio Provision - Metra 99-9011 Instrucciones De Instalación

Double DIN radio provision

1. Cut and remove center divide from
radio housing. (Figure A)
2. Snap the DDIN brackets to the
inside edge of the radio housing.
(Figure B)
3. Slide the DDIN radio into the DDIN
bracket/radio housing assembly
and secure the radio to the kit
using the screws supplied with
the radio. (Figure C)
4. Snap the DDIN trim-plate onto the
housing/radio assembly. (Figure C)
5. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation.
6. Reassemble dash in reverse order
of disassembly.
Kit Assembly
(Figure A)
(Figure B)
(Figure C)
99-9011

Stacked ISO radio provision

1. Cut and remove center divider
from radio housing. (Figure A)
2. Snap the DDIN brackets to the
inside edge of the radio housing.
(Figure B)
3. Slide the stacked ISO DIN radios
into the DDIN bracket/radio
housing assembly and secure the
radios to the kit using the screws
supplied with the radios. (Figure C)
4. Snap the DDIN trim-plate onto the
housing/radio assembly. (Figure C)
5. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation.
6. Reassemble dash in reverse order
of disassembly.
7
(Figure A)
(Figure B)
(Figure C)