Chauvet Professional EPIX DRIVE 642 Guía De Referencia Rápida página 5

EN
Mounting
The ÉPIX™ Drive 642 has four (4) mounting points (one on each corner) with 13
mm holes to which you can install screws and mount this product directly to
almost any flat surface, truss, or other load bearing structure in any orientation.
The product may also be installed with clamps for hanging on truss. You must
supply your own clamps and make sure the clamps are capable of supporting
the weight of this product.
Mounting Guidelines
Chauvet recommends using the following guidelines when mounting this
product:
·
Make sure to mount this product away from any flammable material as indicated
in the Safety Notes
·
Never mount in places where rain, high humidity, extreme temperature changes,
or restricted ventilation may affect the product.
·
Before deciding on a location, always make sure there is easy access to
the product for maintenance and programming.
·
Make sure that the structure or surface onto which you are mounting the
product can support the product's weight (see the
Specifications).
·
When mounting the product overhead, always use a safety cable.
Mount the product securely to a rigging point, such as an elevated
platform or a truss.
·
When rigging the product onto a truss, you should use a mounting
clamp of appropriate weight capacity.
·
When mounting the product on the floor, make sure that the product and
cables are away from people and vehicles.
section.
5
ÉPIX™ Drive 642 QRG
Technical