Rollplay Volkswagen Camper Van Push Buggy Manual Del Usuario página 6

EN
Manual for assembly and use:
The Volkswagen type 2 (T1) is officially licensed by Volkswagen. Manufactured and
distributed by or for Paragon Child Products Co., Ltd. (Goodbaby Group).
Trademark "VW-in-circle logo", associated design patents and copyrights are used with the
approval of the owner Volkswagen AG.
With canopy
Easy access door
Authentic dashboard
Warning
WARNING
TO AVOID SERIOUS INJURY
1. Continuous adult supervision required and adult assembly only.
2. This vehicle is not suitable for children over 48 months due to
4. Never use near motor vehicles, streets, roadways, alleys, swimming
pools, hills, steps driveway, sloped driveways inclines and motor ways.
5. Only one child should ride at a time.
6. The user should always remain seated and facing forward while using
this vehicle.
7. Make sure that the child's feet are on the footrest before pushing the
vehicle.
8. Children should always wear shoes when riding.
9. Do not allow children to stand in the vehicle at any time.
10. Never ride the vehicle outside at night.
11. Never use in wet weather.
12. Maximum user weight is 20kg.
13. Fasten the seat belt properly before use.
14. There are additional hazards of using the toy in areas other than private
grounds.
16. The vehicle must be used with caution since skill is required to avoid falls
or collisions causing injury to the user and third parties.
17. Periodically check the hardware and tighten if necessary. Replace worn
or broken parts immediately.
19. Protective equipment should be worn.
WARNING
TO AVOID BATTERY LEAKAGE
1. Do not mix old and new batteries.
2. Do not mix alkaline, stand ard (carbon-zinc), or rechargeable (nickel
cadmium) batteries.
4. Non-rechargeable batteries are not to be recharged.
5. Rechargeable batteries are only to be charged under adult supervision.
6. Rechargeable batteries are to be removed from the vehicle before being
charged.
7. Be sure to insert the batteries correctly and always follow the vehicle and
battery manufacturer's instruction.
8. Weak or exhausted batteries are to be removed from the vehicle.
9. Do not short-circuit the supply terminal.
Assembly Instructions
1. Assemble wheels:
a). Assemble front wheels: put a washer, a front wheel and a
washer successively into front wheel shaft, insert snap pin into
hole of front wheel axle, and then assemble wheel trim on front
wheel (assemble front wheel on the other side in the same way).
b). Assemble rear wheels: pull out a washer part of rear wheel
axle, put a washer, a rear wheel orientation rod and a washer into
rear wheel axle, put rear wheel trim wheel axle, put a washer onto
axle, and insert snap pin into hole of rear axle, and then assemble
wheel trim on rear wheel (assemble rear wheel on the other side
in the same way). Note: when assembling rear wheels, rear axle's
position needs to be adjusted horizontally for appearance.
2. Assemble steering wheel:
As shown in figure, put steering wheel on top of steering rod, so
that holes on bottom of steering wheel are aligned to holes on
steering rod. Then take out M5 bolts and M5 nuts from small
components package, put them into bolt holes and tighten with
tools.
3. Assemble steering wheel battery:
As shown in figure, purchase two AAA 1.5V batteries, open
battery cover with a screwdriver, put batteries into the bin with
correct polarity, and then assemble battery cover. Note: follow
these steps to replace batteries when the music of steering wheel
becomes lower.
4. Assemble saddle:
As shown in figure, hook saddle on the back into vehicle, and then
push fastener beneath saddle head into second slot on vehicle
until a "click" sound, which means saddle has been successfully
assembled.
5. Assemble vehicle roof:
Use tools to remove M5×28 bolts and M5 nuts from roof support,
align them with cover holes and roof support and tighten with
tools.
6. Assemble vehicle roof components:
As shown in figure a, align canopy rod down to saddle holes, use
tools to press spring head until a "click" sounds, which means
assembly has been successfully accomplished.
As shown in figure b: Canopy can be folded.
7. Assemble push bar:
As shown in figure, insert push rod into holes on the end with long
side of push rod facing forward (in driving direction), until a "click"
sound, which means push rod has been successfully assembled.
Operating Instruction
8. Open doors:
The door on left side of vehicle can be opened.
9. Steering wheel function:
As shown in figure, steering wheel controls to turn left or right;
press buttons on it can simulate sounds of start-up and horn.
10. Use push rod:
As shown in figure, push rod can be adjusted to high or low
position. When adjusting, push adjustable button on push rod and
then push down or pull up to adjust position of push rod and
steering function. As shown in figure, push rod can be removed by
pressing down button on push rod and pull out it at the same time.
11. Pedal function:
As shown in figure, for pushing; remove pedal, carry the child onto
saddle, fasten safety belt and then the vehicle can be pushed. For
walking aid: pull up button beneath saddle, push pedal completely
beneath saddle, then release button, and the child can slide with
both feet on the ground for walking aid.
Please make sure that the footplate need to be pulled to a fixed
position until you hear a click when the lock buttonis inserted in
place.
12. Remove saddle:
As shown in figure, pull two buttons on vehicle bottom simultane-
ously in the direction of the arrow, release saddle fastener, and
then remove saddle in the direction of the arrow from vehicle.
13. Special instruction:
Roof rod plug is a spare part, which should not be used when
using vehicle roof. As shown in figure, put the plug into seat hole if
vehicle roof is not used in future.
14. Align the bottom of the mirror (14) with the hole on the car
body.
Care
MAINTENANCE
1. Before assembly please check that you have all the parts, if there are any
missing parts please contact your local store.
2. Once assembled please inspect all the parts and ensure the vehicle is
working properly.
3. Please carefully clean the product occasionally and not destroy any parts.
4. In order to keep your child safe, please inspect and maintain the vehicle
periodically.
5