Double Din Radio Provision - Metra 99-7010 Instrucciones De Instalación

Mitsubishi eclipse/ eclipse spyder 2006-2012
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS FOR PART 99-7010

Double DIN radio provision

1. Cut the center bar rib. (Figure A)
2. Slide the appropriate bracket into the kit
aligning the holes in the kit with the holes on
the bracket.
3. Slide the double DIN radio radio into the
double DIN bracket/radio housing assembly
and secure the radio to the kit using the
screws supplied with the radio. (Figure B)
4. Snap the double DIN trim plate into the kit.
(Figure B)
5. Locate the factory wiring harness in the
dash. Metra recommends using the proper
mating adapter from Metra or AXXESS. Re-
connect the negative battery terminal and
test the radio for proper operation.
6. Reassemble dash in reverse
order of disassembly.
METRA. The World's best kits.
Cut center
bar rib
(Figure A)
(Figure B)
1-800-221-0932
metraonline.com
© COPYRIGHT 2004-2013 METRA ELECTRONICS CORPORATION
K
P
NOWLEDGE IS
OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians

Publicidad

Tabla de contenido
loading

Tabla de contenido