Dash Disassembly - Metra 99-8151 Instrucciones De Instalación

1. Using a panel removal tool, unsnap
and remove the liner from the tray
above the center vents. (Figure A)
2. Remove (2) Phillips screws from
inside the tray. (Figure B)
3. Using a panel removal tool, unsnap
and remove the center trim panel
including the vents and tray. (Figure C)
4. Using a panel removal tool, unsnap
and remove the switch panel
below the radio. (Figure D)
5. Remove (4) 10mm bolts securing
the radio/climate control assembly,
unplug, and then remove the
assembly. (Figure E)
6. Remove (4) Phillips screws securing
the climate control panel to the
radio/climate control assembly, and
then unplug and remove the panel.
Note: The climate control panel and
screws will be reused in kit preparation.
Continue to kit preparation

Dash Disassembly

(Figure A)
(Figure B)
99-8151
(Figure C)
(Figure D)
2
(Figure E)