Kit Preparation; Din & Iso Din Radio Provision With Pocket - Metra 99-8151 Instrucciones De Instalación

DIN & ISO DIN radio provision
with pocket
1. Remove the ISO DDIN trim plate
from the radio housing, and then
insert the pocket trim plate into
the bottom opening of the radio
housing. (Figure A)
Note: The curved edges should
face upward.
2. Secure the pocket to the pocket
trim plate using (2) #8 x 3/8"
Phillips truss head screws provided
with the kit. (Figure B)
Note: The Metra logo stamped
onto the back of the pocket should
be upside down.

Kit Preparation

(Figure A)
(Figure B)
99-8151
3. Secure the radio brackets to the
radio-housing/pocket assembly
using the supplied (2) #8 x 3/8"
Phillips truss head screws at the
top, and (2) #8 x 3/8" Phillips pan
head screws at the bottom. (Figure C)
4. Mount the rear support bracket to
the back of the pocket using (2) #8
x 3/8" Phillips truss head screws
provided with the kit. (Figure D)
5. Align and engage the (3) tabs
on the bottom of the climate
control panel removed in dash
disassembly to the top edge of
the completed assembly. Secure
the climate control panel to the
assembly using the (4) factory
Phillips screws previously removed
from the climate control panel in
dash disassembly.
Continue to kit assembly
3
(Figure C)
(Figure D)