Iso Din Radio Provision With Pocket - Metra 99-8151 Instrucciones De Instalación

ISO DIN radio provision with pocket

1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
2. Secure the ISO snap-in brackets
to the radio using the screws
supplied with the radio. (Figure A)
3. Slide the radio into the radio
housing assembly until it snaps
into place. (Figure B)
4. Snap the ISO DIN trim plate onto
the front of the radio housing
assembly. (Figure C)
5. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio and climate
controls. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Reconnect the
negative battery terminal and test
the radio for proper operation.
6. Reassemble the dash in reverse
order of disassembly.
Kit Assembly
(Figure A)
99-8151
(Figure B)
6
(Figure C)