Water Connection, Con't (Steam Model Only) - Electrolux EIMED60JIW Instrucciones De Instalación

Installation Instructions
16

Water connection, con't (Steam Model only)

5. If your installation has room for the COLD
water supply to accept the "Y" connector
directly, thread the "Y" connector to the COLD
water supply and snug it by hand; then tighten
it another 2/3 turn with pliers.
NOTE
If you were able to install the "Y" connector directly
to the COLD water supply, please skip to step 8.
6. If there is not room to install the "Y" connector
directly, thread the short extension hose on to
the COLD water supply and snug it by hand;
then tighten it another 2/3 turn with pliers.
7. Thread the "Y" connector to the short
extension hose and snug it by hand; then
tighten it another 2/3 turn with pliers.
8. Connect the COLD inlet hose for the washer
to the "Y" connector and snug it by hand; then
tighten it another 2/3 turn with pliers.
9. Connect the straight end of the long hose from
the kit to the other outlet on the "Y" connector
and snug it by hand. Connect the hose's 90°
coupling to the brass water inlet on the back
of the dryer and snug it by hand. Tighten each
connection of the dryer inlet hose another 2/3
turn with pliers.
10. Turn on the water and check for leaks at all
connections.
DIRECT CONNECTION
OR WITH EXTENSION
WATER INLET ON DRYER
COLD WATER SUPPLY
HOSE TO WASHER