Electrolux EIMED60JIW Instrucciones De Instalación página 18

Secadora eléctrica y a gas de carga frontal
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions
18
Performing Installation Cycle
WARNING
Before operating the dryer, make sure the dryer
area is clear and free of combustible materials,
gasoline, and other fl ammable vapors. Also
see that nothing (such as boxes, clothing, etc.)
obstructs the fl ow of combustion and ventilation air.
With your dryer in fi nal location, perform an Installation Cycle to assist in proper installation.
If your dryer has this console:
1.
Empty dryer's drum and close door.
2.
After you plug in the dryer the fi rst time: wake up the dryer by pressing any button, rotate cycle knob to cycle one
up from lower right position (1), press the start button (3) and then the cancel button (4).
3.
Wake up the dryer again by pressing any button, then immediately and simultaneously press and hold buttons
and 2b for 5 seconds, or until the LCD display changes.
4.
The LCD window will display
The Installation Cycle will automatically perform various diagnostic routines. At cycle completion, the LCD window
may display INSTAL PASS!, meaning your new dryer is properly installed and ready for use. If it prompts an action
such as SERVICE CORD, NO GAS or call service 877 435 3287, review the installation steps and make the necessary
corrections before you attempt to use the dryer.
5.
Your dryer will exit the Installation Cycle and return to normal operation the next time you wake it up.
Dryer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the
dryer through a drying cycle, press the cancel button to put the unit to sleep and then rewake it
immediately to continue the normal operating mode.
6.
Please read the
If your dryer has this console:
1.
After you plug in the dryer the fi rst time: wake up the dryer by pressing any button and follow the prompts on the
LCD User Interface, including language selection.
2.
The Installation Cycle will automatically test for correct cord connection (on electric models), presence of gas sup-
ply (on gas models) and free fl ow of exhaust vent. At cycle completion, the LCD user interface may display INSTAL
PASS!, meaning your new dryer is properly installed and ready for use. If it prompts an action such as SERVICE CORD,
NO GAS or call service 877 435 3287, review the installation steps and make the necessary corrections before you
attempt to use the dryer.
3.
Your dryer will exit the Installation Cycle and return to normal operation the next time you wake it up.
Dryer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the
dryer through a drying cycle, press the cancel button to put the unit to sleep and then rewake it
immediately to continue the normal operating mode.
4.
Please read the
FIRE HAZARD
INSTAL CYCLE and show estimated time of cycle completion. Press the start button.
NOTE
Use & Care Guide and enjoy your new premium dryer!
NOTE
Use & Care Guide and enjoy your new premium dryer!
NOTE
On gas dryers, before the burner will light, it is
necessary for the gas line to be bled of air. If the
burner does not light within 45 seconds the fi rst
time the dryer is turned on, the safety switch will
shut the burner off. If this happens, press cancel
and wait 5 minutes before making another
attempt to light.
2a
1
3
4
2b
2a

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ewmgd70jrr

Tabla de contenido