Unpacking The Range - Thermador PROFESSIONAL PRO HARMONY PRD304GHC Manual De Instalación

Unpacking the Range

1. Remove the outer carton and packing materials from
the shipping pallet but leave the adhesive-backed foam
layer over brushed-metal surfaces, to protect finish
from scratches, until the range is installed in its final
position.
2. It is recommended that the grates, griddle plate, burner
caps and oven racks be removed to facilitate handling.
If desired, the oven doors may also be removed (see
"Step 8: Door Removal and Adjustment" on page 23).
Do not remove the griddle assembly.
Shipping Weight
Weight without
packing materials
Moving the Range
DO NOT lift the range by the oven door's handle, as this
may damage the door hinges and cause the door to fit
incorrectly.
Due to the weight, a furniture dolly with soft wheels or an air
lift should be used to move this unit. The weight must be
supported uniformly across the bottom.
NOTICE:
The electric wire diagrams and schematics are attached
behind the kick panel, and should not be removed except
by a service technician, then replaced after use.
English 10
30" 36"
Range Range Range
377 lbs 395 lbs 560 lbs
(171 kg) (179 kg) (254 kg)
293 lbs 337 lbs 470 lbs
(133 kg) (153 kg) (213 kg)
Table 2: Range Weight
CAUTION:
Removing the Pallet Bolts
1. To remove the (4) pallet bolts in the front and in the
back, use a 7/16" wrench or ratchet and socket to
remove the pallet bolt from the bottom of the pallet.
Discard the wood packing block inserts.
48"
2. Lift range and remove it from the pallet. Use additional
help as required to remove from pallet.
3. Transport the range by dolly close to its final location.
Unit should not be dollied from the front.
4. The range can then be tipped back and supported on
the rear legs while the dolly is carefully removed. THE
FLOOR UNDER THE LEGS SHOULD BE
PROTECTED BEFORE PUSHING THE UNIT INTO
POSITION.
• Step 4 through Step 8 must be completed before
the range is placed in its final position. For proper
performance, the range must be level. See
"Step 9: Placing and Leveling the Range" on
page 24 for leveling instructions.
Figure 6: Removal of Shipping Bolts