Step 3: Unpacking, Moving And Placing The Range - Thermador PROFESSIONAL PRO HARMONY PRG305PH Manual Del Usuario

STEP 3: Unpacking and
Moving the Range
CAUTION
DO NOT lift the range by the oven door's
handle, as this may damage the door hinges
and cause the door to fit incorrectly.
DO NOT lift the appliance by the range's
control panel.
The unit is heavy and should be handled
accordingly. Proper safety equipment such as
gloves and adequate manpower of at least two people
must be used in moving the range to avoid injury and to
avoid damage to the unit or the floor.
Rings, watches, and any other loose items that may
damage the unit or otherwise might become entangled
with the unit should be removed.
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.
DO NOT use a hand truck or appliance dolly on the back
or front of the unit. Handle from the side only.
Unpacking the Range
NOTE: DO NOT remove control panel foam until unit is
completely installed. DO NOT lift on the control panel at
any point during the installation.
1. Remove the outer carton and packing materials from
the shipping pallet but leave the adhesive-backed foam
layer over brushed-metal surfaces, to protect finish
from scratches, until the range is installed in its final
position.
2. It is recommended that the grates, burner caps and
oven racks be removed to facilitate handling. If desired,
the oven doors may also be removed (see "STEP 8:
Door Removal and Adjustment" on page 18).
Installation Instructions
Moving the Range
Due to the weight, a furniture dolly with soft wheels or an
air lift should be used to move this unit. The weight must be
supported uniformly across the bottom.
NOTE: STEP 4 through STEP 8 must be completed before
the range is placed in its final position. For proper
performance, the range must be level. See "STEP 9:
Placing and Leveling the Range" on page 19 for leveling
instructions.
Removing the Pallet Bolts
1. To remove the (4) pallet bolts in the front and in the
back, use a 7/16'' wrench or ratchet and socket to
remove the pallet bolt from the bottom of the pallet.
Discard the wood packing block inserts.
Figure 6: Removal of Shipping Bolts
2. Lift range and remove it from the pallet. Use additional
help as required to remove from pallet.
3. Transport the range by dolly close to its final location.
Unit should not be dollied from the front.
4. The range can then be tipped back and supported on
the rear legs while the dolly is carefully removed. THE
FLOOR UNDER THE LEGS SHOULD BE
PROTECTED BEFORE PUSHING THE UNIT INTO
POSITION.
English | 11 |