Step 3: Unpacking, Moving And Placing The Range - Thermador PRO-HARMONY P304 Instrucciones De Instalación

Step 3: Unpacking, Moving and Placing the Range

Caution
Proper equipment and ad-
equate manpower must be
used in moving the range to
avoid injury, and to avoid
damage to the unit or the
floor. The unit is heavy
and should be handled
accordingly.
• The range has an approximate
shipping weight as shown in
Chart A. It is recommended that
the grates, griddle plate and
frame, burner caps, front kick
panel and oven racks be re-
moved to facilitate handling.
This will reduce the weight as
shown in Chart A and allow the
range to pass through 30" door-
ways. See Figs. 2A and 2B on
Page 6. Do not remove the
grill or griddle assemblies.
• Remove the outer carton and
packing material from the ship-
ping base. The all gas ranges
are held to the pallet by four (4)
bolts (see Fig. 4). After remov-
ing the bolts, the range must be
lifted and removed from the
pallet.
• Remove angle-mounting brack-
ets from range. This requires
the installer to remove two
screws holding each bracket
then remove bracket and rein-
stall screws.
• Important: DO NOT lift the range
by the oven door's handle, as
this may damage the door
hinges and cause the door to fit
incorrectly to the oven cavity.
Chart A
Shipping Weight
Weight without
packing materials
Without door(s),
burner caps, front kick
panel and oven racks
FIG. 4 – Removal of the Four(4) Shipping Bolts
Pallet
9
30" Range 36" Range
300 lbs. 335 lbs.
265 lbs. 300 lbs.
142 lbs. 207 lbs.