Genie Z-62/40 Manual Del Operario página 10

Manual del operario
Seguridad general
DANGER
Tire Pressure:
70 psi / 4.92 bar
Lug Nut Torque:
Tip-over Hazard
Dry bolts:
Failure to replace tires with tires
240 ft-lbs /
of same specification will result
325 Nm
in death or serious injury.
Lubricated bolts:
Tires are critical to machine
180 ft-lbs /
stability.
244 Nm
Do not replace factory-installed
tires with high flotation tires.
Only replace factory-installed tires
with tires of same specification and
ply rating.Tire Size: 355/55 D625,
14 ply
82677 D
WARNING
Compartment access
Only trained maintenance personnel
is restricted.
should access compartments. Access
Contact with
by operator is only advised when
components under
performing Pre-operation Inspection.All
any cover may result
compartments must remain closed and
in serious injury.
secured during operation.
28175 H
8
DANGER
Maintain required clearance.
Line Voltag e Required Clearance
0 o t 5 0 K V 1 0 t f 3 0 . m
Electrocution Hazard
50 to 200KV 15 ft 4.6 m
Death or injury can result from contacting electric
200 to 350KV 20 ft 6.1 m
power lines.
350 to 500KV 25 ft 7.6 m
Always contact the electric power line owner. The
500 to 750KV 35 ft 10.6 m
electric power shall be disconnected or the power
lines moved or insulated before machine operations 750 to 1000KV 45 ft 13.7 m
begin. 114390 A
WARNING
Electrocution Hazard
Failure to properly connect
and use the weld line to
platform could result in death
or serious injury.
Read, understand and obey all
Do not use ether or
warnings and instructions
Explosion Hazard other high energy provided with welding power unit.
Death or serious injury can starting aids on Turn welding power unit off
before connecting leads.
result from the use of ether or machines equipped
Be sure weld cables are properly
other high energy starting with glow plugs.
connected.
aids.
97602 B
DC weld only: 40V, 300 amp
maximum.
Primera edición • Primera impresión
DANGER
DANGER
Burn Hazard No smoking. No
Fuel and fumes flame. Stop
can explode engine.
and burn.
114258 A
WARNING
Component Damage
Hazard
Failure to properly
connect weld leads
may result in machine
or component
damage.
Turn welding power unit
off before connecting
leads.
Connect leads to twist-
lock connectors at
turntable and platform.
97875 A
Z-62/40
DANGER
Tip-over Hazard
Altering or disabling limit
switches can result in machine
Electrocution
tip-over. Machine tip-over will
Hazard
result in death or serious injury.
Contact with
Avoid contact
energized
with energized
components can
components.
result in death or
Do not alter or disable limit
82237 B
serious injury.
switch(s).
31060 C
N.º de pieza 1257652SP