Sharp 902 Manual De Instrucciones página 241

Precauciones de seguridad y condiciones de uso
The exposure standard for wireless mobile phones employs a unit of measurement known
as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.* Tests
for SAR are conducted using standard operating positions specified by the FCC with the
phone transmitting at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level of
the phone while operating can be well below the maximum value. This is because the phone
is designed to operate at multiple power levels so as to use only the power required to reach
the network. In general, the closer you are to a wireless base station antenna, the lower the
power output.
Before a phone model is available for sale to the public, it must be tested and certified to
the FCC that it does not exceed the limit established by the government-adopted
requirement for safe exposure. The tests are performed in positions and locations (e.g., at
the ear and worn on the body) as required by the FCC for each model. The highest SAR value
for this model phone when tested for use at the ear is 0.530 W/kg and when worn on the
body, as described in this user guide, is 0.386 W/kg. Body-worn Operation; This device was
tested for typical body-worn operations with the back of the phone kept 1.5 cm from the
body. To maintain compliance with FCC RF exposure requirements, use accessories that
maintain a 1.5 cm separation distance between the user's body and the back of the phone.
The use of belt-clips, holsters and similar accessories should not contain metallic
components in its assembly.
The use of accessories that do not satisfy these requirements may not comply with FCC RF
exposure requirements, and should be avoided. While there may be differences between
the SAR levels of various phones and at various positions, they all meet the government
requirement for safe exposure.
240