Important; Remote Control Installation (Optional) - Thermador PH30HWS Manual De Instrucciones

Ocultar thumbs Ver también para PH30HWS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Built-in Remote Control
Accessory (optional)
Before you begin, read these instructions carefully. It is
recommended that the Remote Control be wired to the
hood after the hood is installed.
REMCPW Parts Included
1 – Remote control
1 – 30 ft. extension harness
IMPORTANT: Cutting off a connector to the appliance or
to the extension cable kit will void the warranty.
Remote Control Installation
1. Prepare the wall (or similar surface) cutout for
installation as shown below (view is shown facing wall).
5
/ "
2
8
(65)
2. Access the hood's wiring. Route the 30 ft. extension
harness through the strain relief to the square
mounting clip until it clicks.
3. Route the 30 ft extension harness through the cutout
and connect the harness to the back of the remote
control bracket.
Page. 20
5
/ "
13
8
(346)
inches (mm)
4. Press the bracket inside the cutout. Drill a ¼'' (6 mm)
tap hole through the bracket holes into the wall.
Mount the bracket to the wall using the four (4) screws
provided.
inches (mm)
5. Hook up the wire harness connector inside the bracket
to the terminal on the back side of the remote control.
Use either terminal.
6. Snap the Remote Control into the bracket.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ph36hwsPh48hwsPh36gwsPh42gwsPh48gwsPh54gws ... Mostrar todo

Tabla de contenido