Troubleshooting - FLORABEST FHM 2400 B2 Traducción Del Manual De Instrucciones Original

Troubleshooting

Problem
Motor will not
start
Overload protection tripped
Lid of housing not closed
properly
Shredding material is too
soft
Garden waste is
Unit blocked
not drawn in
Shredding material in
discharge duct
Unit won't shred
Blades are blunt
properly
Possible cause
No mains power
supply
Remedy
Check the socket, cable, lead and
plug for damage, and if necessary,
have any damage repaired by
qualified repair personnel.
Wait until the motor has cooled down,
then press the Reset button and restart
the unit
Tightly screw in the housing interlock
Use the pusher or add dry twigs/
branches
See section „Removing blockages"
Remove shredding material from
discharge duct
Check and turn, sharpen or replace
blades as necessary (see section
„Sharpening, turning, replacing the
blades")
GB MT
43