Important Safety Instructions - SMA MD SEN-US-40 Serie Manual Del Usuario

2 Safety SMA Solar Technology AG
The product must only be operated with irradiation sensors that can output a current signal in the
range from 0 mA to 20 mA or 4 mA to 20 mA or a voltage signal in the range from 0 V to +10 V.
The product must only be operated with anemometers with impulse output for S0 impulses in
accordance with DIN EN 62053-31 (IEC 62053-31).
The product must only be operated with energy meters with S0 interface in accordance with
DIN EN 62053-31 (IEC 62053-31).
A list with SMA Sensor Module compatible products is available at www.SMA-Solar.com.
All components must remain within their permitted operating ranges and their installation
requirements at all times.
The product is approved for the US and Canadian market.
Use this product only in accordance with the information provided in the enclosed documentation
and with the locally applicable laws, regulations, standards and directives. Any other application
may cause personal injury or property damage.
Alterations to the product, e.g. changes or modifications, are only permitted with the express written
permission of SMA. Unauthorized alterations will void guarantee and warranty claims and in most
cases terminate the operating license. SMA shall not be held liable for any damage caused by
such changes.
Any use of the product other than that described in the Intended Use section does not qualify as the
intended use.
The enclosed documentation is an integral part of this product. Keep the documentation in a
convenient place for future reference and observe all instructions contained therein.
This document does not replace and is not intended to replace any local, state, provincial, federal
or national laws, regulations or codes applicable to the installation, electrical safety and use of the
product. SMA assumes no responsibility for the compliance or non-compliance with such laws or
codes in connection with the installation of the product.
The type label must remain permanently attached to the product.
2.2

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
This section contains safety information that must be observed at all times when working on or with
the product.
The product has been designed and tested in accordance with international safety requirements. As
with all electrical or electronical devices, there are residual risks despite careful construction. To
prevent personal injury and property damage and to ensure long-term operation of the product,
read this section carefully and observe all safety information at all times.
6 MDSEN-US-40-IS-xx-13 Quick Reference Guide