Power Supply En; Feeding In The Wire En - Abicor Binzel M-Drive MFS-V3 Instructivo De Servicio

6 Putting into operation
6.7 Power supply
The power is supplied via the eBOX.
 Please see the information in the eBOX operating instructions BAL.0388.0.
6.8 Feeding in the wire
1
1 Inching trigger S7
2 Cover
3
Pressure lever
Fig. 8 Feeding in the wire
1 Open the cover (2) on the M-Drive (4).
2 Fold the pressure lever (3) outward and open the pressure rockers (5).
3 Undo the start of wire on the wire basket spool.
4 Feed the wire through the wire inlet (8) over the wire feed rolls (7) and into the euro central
connector (6).
5 Close the pressure rockers (5) and fold the pressure lever (3) back to upper position.
NOTICE
• Set the key-operated switch S1 on the eBOX to MANUAL.
6 With the cover (2) open, press the Inching trigger (1) to feed the wire through the wire guide (cable
assembly or Masterliner) into the process-side drive.
EN - 12
9
4 M-Drive
5 2 pressure rockers
Otherwise, the inching function cannot be used if the cover is open.
2 3
8 7
6 Euro central connector
7 Wire feed rolls
M-Drive
4
5
6
8 Wire inlet
9 Safety switch