Operating Elements Abidrive Cw En; Power Supply Operating Elements En; Putting Into Operation En; Putting Out Of Operation - Abicor Binzel ABIDRIVE CW Manual Del Usuario

TIG cold wire feeder
6.1 Operating elements
 Fig. 4 Overview of connections and operating elements on page EN-9
Symbol
NOTICE
• The dials (7) and (10) only work in the interval mode.
• The dial scales serve exclusively for orientation with respect to the set values.
6.2 Power supply operating elements
 Fig. 4 Overview of connections and operating elements on page EN-9
Symbol
6.3 Putting into operation
 Fig. 4 Overview of connections and operating elements on page EN-9
1 Switch on the (17) power switch.
2 Open the valve of the shielding gas cylinder.

7 Putting out of operation

NOTICE
• Please make sure that the shutdown procedures for all components mounted in the welding system are
 Fig. 4 Overview of connections and operating elements on page EN-9
1 Switch off the (17) power switch.
2 Close the valve of the shielding gas cylinder.
ABIDRIVE CW
Designation
Wire feeder dial (6)
Wire feed rate can be set continuously.
Program selection switch (8)
The following programs can be set: four-stroke, two-stroke, four-stroke interval and two-
stroke interval
Timer / Pause dial (10)
The pause time can be set independently of the wire feeding time.
Timer / Feed dial (7)
The delivery time for the welding wire can be regulated.
Display (9)
The preset wire feed rate is displayed. Changes on the dial (6) are applied the next time
welding is started.
Designation
Power switch (17)
Switching state ON and OFF.
strictly observed before putting out of operation begins.
7 Putting out of operation
EN - 13