Mounting The Light Fixture; Testing And Adjustments; Initial Setup - Heath Zenith DualBrite 4558 Manual De Instrucciones

MOUNTING THE LIGHT FIXTURE

1. Make sure wire connectors and wires are inside the
junction box.
2. Slide the open end of the mounting slots on the light
fixture base onto the mounting screws and rotate the
light fixture base clockwise until it stops.
3. Tighten the mounting screws securely against the light
fixture base.
4. Refer to Testing and Adjustments section before installing
cover.
Mounting Screw
Y
V I T
I T I
5. After the testing and setup is complete, use the two
N S –
S E
+
decorative fixture nuts to install the light fixture cover.
IT Y
IT IV
N S –
S E
+

TESTING AND ADJUSTMENTS

When the "ON-TIME" switch is set to the "TEST" position,
the light fixture will operate during the day or night. The
light will stay on for 10 seconds after all motion is stopped.
1. Turn the power on at the circuit breaker or fuse and turn
on the wall switch. Note: The motion sensor will need
to completely warm up (90 seconds) before beginning
the setup process.
2. Slide the "DualBrite" switch to "OFF".
3. Slide the "ON-TIME" switch to the "TEST" position.
4. Turn the "SENSITIVITY" control to the midway
position (halfway between "+" and "–").
®
I T E
B R
A L
D U
S K
W N
D U
D A
T O
6
3
F
O F
M I N
1 0
5
M E
1
- T I
S T
T E O N
Sensor Lens
Y
V I T
I T I
N S –
S E
+
8 ft . (2 .4 m)
30 Feet (9 .1 m) in
all Directions
Maximum Range
4

Initial Setup

DualBrite
OFF 3 6
HR
TEST 1 5 10 MIN
ON-TIME
SENSITIVITY
+
Sensor Controls
Maximum Coverage
Angle (Top View)
®
DUSK
TO DAWN
HR
–
360°
209987-01