Ec Declaration Of Conformity - Mettler Toledo InFit 76 Serie Manual De Instrucciones

InFit 76X Stationary Housings
6 Maintenance
1. Isolate the pipe / tank / vessel etc. from the housing
(depressurize, empty, rinse, purge and vent, etc.).
2. Remove the sensor from the housing.
3. Remove t he s tationary h ousing f rom t he p ipe / tank / ves-
sel etc. (if changing of housing seal is needed).
h
4. Change the housing seal.
5. Calibrate / clean the electrode / sensor with reference
to sensor and transmitter instruction manuals.
6. Follow the installation and commissioning procedure.
7 Disposal
It is the user's responsibility to dispose of the housing in
a professional manner and in accordance with local
regulations.
8 Warranty
On manufacturing defects, 12 months after delivery.
9 Storage condition
We recommended following the shutdown procedure as
described in the housing instruction manual. The cleaned
and dried housing should be stored at room temperature.

10 EC Declaration of Conformity

The complete declaration is available in the declaration
of conformity certificate.
InFit is a registered trademark of Mettler-Toledo GmbH in
Switzer l and, the USA, the European Union and a further five
countries.
© 02 / 16 Mettler-Toledo GmbH
Printed in Switzerland
P erform step #3 followed by #2
Note:
for InFit 762 / 763.
InFit 76X Stationary Housings
en
13
30 313 392