En Quick Setup Guide; Safety Instructions - Mettler Toledo InFit 76 Serie Manual De Instrucciones

InFit 76X Stationary Housings
Quick Setup Guide
for InFit 76X
1 Introduction
The METTER TOLEDO InFit 76X stationary housings
are i ntended for use in conjunction with specified
METTLER T OLEDO electrodes / sensors, namely pH and
redox (ORP) combination electrodes as well as dissolved
oxygen (DO), CO
Please read through this quick set-up guide and the
operating instructions carefully before commissioning, in
order to ensure trouble-free use. Operating and
maintenance should be carried out only by trained
personnel and staff who have read and understood the
operating instructions.
2

Safety instructions

h
Notice:
checked for:
– Damage to the connections, fastenings, etc.
– Leakage
– Perfect functioning
– Authorization for use in conjunction with other
h
Notice:
responsibility for any damage caused by
unauthorized a ttachments or for the incorporation
of spare parts which are not of METTLER TOLEDO
provenance. The risk is borne entirely by the
operator.
a
Caution:
the operator must have already clarified that use of
the sensor in conjunction with the other associated
equipment and resources is fully authorized.
a
Caution:
nor put into operation. Faulty containment
or installation out of conformance with regulations
and instructions can lead to the escape of medium
or to pressure surges (explosion), potentially
harmful both to persons and to the environment.
a
Caution:
be replaced immediately.
a
Warning:
commencing any maintenance work on it, ensure
that the equipment in which the housing is installed
is in a safe condition (depressurize, no explosion
risk, empty, rinse, vent, etc.).
a
Warning: Please observe, read and fully understand
the special conditions of use for installation in ex-
classified areas.
© 02 / 16 Mettler-Toledo GmbH
Printed in Switzerland
, conductivity or turbidity sensors.
2
Before every start-up, the housing must be
plant equipment and resources.
The manufacturer / supplier accepts no
Before the housing is put into operation,
A defective housing may neither be installed
If an electrode / sensor is broken, it must
Before dismantling the housing or
InFit 76X Stationary Housings
en
11
30 313 392