Assembly And Mounting Instructions - Microsoft Surface Hub 55 Manual De Usuario

Assembly and mounting instructions

Step 1: Attach the wall plate to the wall
A. Mark the wall at the point where you want the center of your Surface Hub screen to be.
Note: Microsoft recommends a center height of 55 inches for the Surface Hub 55" and a center height of 54 inches for the Surface Hub 84".
B. Place the wall plate against the wall, making sure the center mark indicator on the wall plate is over the center height mark you made on the wall and the arrow is pointing up (See the image below).
Note: The arrow on the center mark indicator should point up (see image above).
C. When you're certain the wall plate is level, draw a line on the wall across the top of the wall plate, using its edge as a guide. Then set the wall plate aside.
D. Identify the three studs nearest the center mark on the wall.
E. Mark the center of each stud above the line you just drew.
F. Make another mark 16 inches below each stud mark. Make sure your marks are in the center of each stud.
G. Draw a straight line between the upper and lower marks for each of the three studs.
Note: The pattern should look like the image below (Your center mark may be more to one side or the other).
H. Mark where the stud lines cross the horizontal slots in the wall plate.
Drill here
a. Place the wall plate against the wall. Align the center mark indicator on the wall plate with the center mark on the wall, making sure the arrow is pointing up and the wall plate is level.
b. Mark the wall at each point where a horizontal slot in the wall plate crosses a vertical stud line on the wall (see image above).
Note: If you can't see the line in the slot, move the wall plate left or right until you can.
c. Set the wall plate aside.
4
Center Mark
Center Mark
Stud Mark Lines
K