Microsoft Surface Hub 55 Manual De Usuario página 7

WARNING: Stud alignment
To reduce the risks related to fall hazards, ensure that the mount will attach to three studs and that the screws are mounted at the center of each stud.
I. Loosely secure the wall plate to the left-hand stud.
a. Drill a 7/32-inch pilot hole to a depth of 3 inches at the top mark in the center of the left-hand stud.
b. Align the wall plate over the pilot hole.
c. Place a washer on a lag screw and drive the lag screw into the pilot hole.
Note: Leave the lag screw loose enough to allow the wall plate to move freely.
Note: If you encounter excessive torque while driving in the lag screw, back out the screw and re-drill the pilot hole with the 1/4-inch drill bit.
WARNING: Hidden hazards
Walls can contain electrical wires and other unseen hazards and obstacles such as water or gas lines. It is the installer's responsibility to locate and avoid these hazards during installation. If drilling and/or cutting into the
mounting surface, always make sure that there are no electrical wires, water lines or gas lines in the wall. Cutting or drilling into any of these may cause serious injury or death.
J. Secure the wall plate to the right-hand stud.
a. Drill a 7/32-inch pilot hole to a depth of 3 inches at the top mark in the center of the left-hand stud
Note: If you encounter excessive torque while driving in the lag screw, back out the screw and re-drill the pilot hole with the 1/4-inch drill bit.
b. Align the wall plate over the pilot hole.
c. Place a washer on a lag screw and drive the lag screw into the pilot hole.
d. Make sure that the wall plate is level and that the center mark indicator on the wall plate still aligns with the center mark on the wall.
e. Fully tighten both lag screws until wall plate is clamped flush against wall.
Note: Do not over tighten screws once wall plate is clamped flush against wall.
K. Install the remaining four screws in the same way.
Note: Make sure you align the screws with the vertical lines marking all three studs (see image above).
K
5