Microsoft Surface Hub 55 Manual De Usuario página 8

Step 2: Attach the hanger bars to the Surface Hub
A. Place one of the hanger bars over the left mounting screw holes on the back of the Surface Hub.
Note: Be sure to use the holes closest to the left edge of the display (see image below).
B. Using the hanger bar screws, attach the hanger bar to the mounting screw holes.
C. Tighten the screws securely, but do not overtighten.
D. Repeat these steps with the other hanger bar.
WARNING: Ensure screws are securely tightened
To reduce the risk of the product falling, ensure that all screws are securely tightened to their specified torque values before mounting the display. Do not overtighten.
6
K