Hi/Low Power Selection (Only In Pmr446 Band) - Midland G9 Manual De Uso

tone blinks on the right ("of"= no code – default condition).
Select the desired CTCSS tone by pushing ▲▼.
4.
5. To confirm the setting, push PTT or wait for 5 seconds.
Deactivating the CTCSS tones:
If you don't want to use the CTCSS tones, follow these steps:
1. Select the desired channel
Press the MENU key till the display shows the CTCSS tone blinking
2.
on the left;
Select "of" by means of ▲▼.
3.
Activating the DCS codes:
1. Turn on the unit.
Select the desired channel by pressing MENU and ▲▼ keys.
2.
3. Push the MENU button again till the display shows DCS and the tone
code blinks on the right ("of"=no code – default condition).
Select the desired DCS code by pushing ▲▼.
4.
5. To confirm the setting, press the PTT or wait for 5 seconds.
Channel P8 with DCS tone 50 (P850) has been set at factory for the "Emer-
gency" function; do not use it for general communications!!
Deactivating the DCS codes:
1. Select the desired channel.
Press the MENU key till the display shows the channel in use and the
2.
DCS code blinks on the right.
Select "of" by pushing ▲▼.
3.

Hi/low power selection (only in PMR446 band)

1. To select the power level, press the MENU button till the display
shows Pr.
Use ▲▼ to select L (low power) or H (high power).
2.
To confirm your selection, push PTT or wait for 5 seconds.
3.
When the batteries are fully charged, the high power is 500 mW (ERP),
while the low is 10mW (ERP).
If your radio has to operate within a short range, you can select the low
power and therefore extend the battery life.
On LPD channels (only for G9 Plus Dual band version) the output power
16 | Midland G9/G9E Plus instruction guide