Rega Planar 1 Plus Manual Del Usuario página 3

1 English
3 Français
5
Deutsch
7 Italiano
9 Español
11 Português
13 Nederlands
15 Dansk*
17 Svenska*
19 Polski*
Setting up your Planar 1 Plus
• Carefully unpack the turntable, always keeping it upright.
• Check the belt is fitted around the drive pulley (A) and sub-platter (B).
• Remove the packing card (C) from beneath the sub-platter (B) and fit the platter (1) and mat.
• Push the balance weight (4) fully onto the rear of the tonearm (3) until it reaches the stop
point as shown (D).
• Connect the phono output to an appropriate line level input (see page 2).
• Connect the power supply to the rear of the turntable (see page 2).
• Carefully remove the stylus guard from the cartridge (2).
• Turn on the Planar 1 Plus via the on/off switch located on the underside of the plinth (5).
• Change the speed by moving the drive belt from the 33 1/3 and 45 steps of the pulley (A).
• The RB110 tonearm (3) is preset for bias adjustment, no other set-up is required.
1
5 (the on/off switch is located
underneath the plinth)
• IMPORTANT: Please turn down the volume on the amplifier before switching
the unit on or off.
A, B & C (located
beneath the platter)
D
4
3
331/3 rpm
45 rpm
2
Stop point
A
B
C
A
D
1