Symbols - koban KP 2102 Manual Del Usuario

Pinza amperimétrica digital
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

KP 2102
Digital clamp meter
range is unknown.
Disconnect the test leads from the
circuit under test before turning the
rotary selector to change functions.
Do not measure the resistance,
capacitance, diode or continuity of
live circuits.
Do not connect the meter to any
voltage source while the rotary
selector is in the current, resistance,
capacitance, diode or continuity
range.
Do not take capacitance
measurements until the capacitor
to be measured has been fully
discharged.
Do not use the meter near explosive
gases, steam or dirt.
Stop using the meter if any
abnormalities or faults are observed.
Do not use the meter unless its rear
case and battery cover is securely
fastened in its original position.
Do not store or use the meter in
areas exposed to direct sunlight,
at high temperature or with high
relative humidity.

Symbols

Caution, risk of danger
(Important safety
information; refer to the
operation manual.)
Application around and
removal from HAZARDOUS
LIVE conductors is
permitted.
Instructions manual |
26
Earth ground
Double insulation
(Protection classⅡ)
Overvoltage (Installation)
category III, Pollution
CAT
Degree 2 per IEC1010-
III
1 refers to the level of
Impulse Withstand Voltage
protection provided.
Conforms to European
Union Directive
Maintenance
Do not attempt to remove the
rear case to adjust or repair the
meter. Such actions should only
be performed by a technician who
fully understands the meter and the
danger involved.
Before opening the case and battery
cover of the meter, always disconnect
test leads from all sources of electric
current. Disconnect the test leads
from all sources of electric current
before opening the rear case and
battery cover of the meter.
To avoid any electric shock caused by
error readings, replace the batteries
immediately when the "
appears on the display.
www.grupotemper.com
" sign

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido