Measuring Dc Current - koban KP 2102 Manual Del Usuario

Set the rotary selector to the 40A or
400A range position.
push the REL key make sure the LCD
display zero if the unsteady reading
appear before measurement.
Press the trigger to open jaw. Fully
enclose only one conductor.
Take the reading on the LCD.
NOTE:
1. Do not put more than one
cable into the jaw during test,
otherwise incorrect test value
might be obtained.
2. For optimum results, center the
conductor in the jaw.
3. At the manual range mode,
when only 'O L' is shown on the
LCD, it means the measurement
has exceeded the range. A
higher range should be selected.
4. If the scale of the value to
be measured is unknown
beforehand, set the range to the
highest.
" means the maximum input
5. "
current is 400A rms AC.

Measuring DC Current

WARNING
Beware of Electrocution.
Ensure that the test leads are
disconnected from the meter
before making current clamp
measurements.
Set the rotary selector to the 40A or
www.grupotemper.com
Digital clamp meter
400A range position.
Press the SEL key turn to DC current
measurement mode.
Press the "REL" button, the meter
will be set to zero.
Press the trigger to open jaw. Fully
enclose only one conductor.
Take the reading on the LCD.
Symbol "-" will be displayed on
LCD if the direction of the current is
negative.
NOTE:
1. Do not put more than one
cable into the jaw during test,
otherwise incorrect test value
might be obtained.
2. For optimum results, press the
"REL" button to make the
meter get into zero first.
3. For optimum results, center the
conductor in the jaw.
4. At the manual range mode,
when only "O L" or "-O L" is
shown on the LCD, it means the
measurement has exceeded the
range. A higher range should be
selected.
5. Under the manual range mode,
when the scale of the value
to be measured is unknown
beforehand, set the range to the
highest.
6. " " means the maximum input
current is 400A DC.
Instructions manual |
KP 2102
37