Installation Overview; Connecting The Hardware; Mounting The Axis 5570E - Axis 5570e Guia De Instalacion

AXIS 5570e Installation Guide

Installation Overview

To get your print server up and running on your network, follow the instructions below:
• Connect the AXIS 5570e to your network and to your printer as described in

Connecting the Hardware.

• Proceed to Setup and Configuration to determine which setup procedures that are
relevant to your network environment.
• Proceed to Print Server Management and Configuration for information on supported
management and configuration tools.
Connecting the Hardware
Follow these instructions to make your printer network ready:
1. Switch off the printer(s) and disconnect the AXIS 5570e power adapter.
2. Locate the serial number, found on the backside label of the print server, and write it down. You will need this
number during the network configuration.
3. Connect the print server to the printer(s).
4. Connect the print server to the network using a twisted pair RJ45 cable (of category 5 or better).
5. Switch on the printer(s) and connect the power adapter to the AXIS 5570e. The power indicator lights up.
When the network indicator starts to flash, the print server is correctly connected to the network.
6. Wait 1 minute and press the test button once. A test page will be printed on the connected printer — keep it
handy during the installation. The test page will show the assigned IP address of the print server.

Mounting the AXIS 5570e

Using the supplied clip and holder, your AXIS 5570e can be mounted in many ways, e.g. on the back of the printer
or on a wall.
Adhesive Clip
Adhesive Holder
Proceed to Setup and Configuration to determine which setup procedures that are relevant to your network
environment.
Fasten to print server by peeling off adhesive tape.
Fasten to mounting surface by peeling off adhesive
tape.
Page 7