Publicidad
Idiomas disponibles
Idiomas disponibles
Check that the mains voltage corresponds to that indicated on the nameplate.
Use cable sleeves made out of polychloroprene or other similar materials (H05RN-F), for the connection.
A switch device should be installed next to the appliance for all the phases, with a gap of a minimum of 3
mm between contacts. This switch will be equipped with fuses.
It is obligatory to earth the appliance. The manufacturer takes no responsibility if this requirement is not
fulfilled.
The section of cable sleeve and the rating of the fuses to be installed in the power switch are indicated in
diagram no. 2.
VERY IMPORTANT: Before putting the switchboard top on, fasten the electric supply cable tightly to the
stuffing box.
When several appliances are installed in series, they should be earthed to each other using the point
assigned for this purpose, located in the appliance's base, at the back.
Turning the table plates on
e)
Press the power switch situated on the outside of the appliance.
f)
Turn the "M" control (Fig. 2) of the switch corresponding to the plate you want to turn on, to the
chosen position or power, and then the "P1" pilot light will turn of (Fig. 2) telling us that the
chosen plate and power are working.
Turning the table plates off
c)
If you want to turn the plate off, turn the "M" control to the "OFF" position (Fig. 2). The burner
will turn off in this position.
Turning the oven on
g)
Once the heating system has been decided upon (Fig. 4), turn the "MHG" control to the
desired position. The pilot "P2" (green) will then turn on, indicating that the oven is ready for
operation.
h)
Select the temperature according to table no. 3, turning the "MTH" control to the chosen
position. Pilot "P3" (amber) will turn on indicating that the resistors are working.
i) When the oven reaches the selected temperature, the resistors stop working (by means of the
thermostat) and the "AMBER" pilot will turn off.
Additionally, as soon as the selected value lowers, the resistors will start to work and the
"AMBER" pilot will turn on.
Turning the oven off
c)
Turn the "MTH" and "MHG" controls to the "OFF" position. The "AMBAR" and "VERDE" pilot
lights turn off.
2.-USE
Turning the appliance on
18
Publicidad
