Description Of The Appliance; Starting Up For The First Time; Your Vacuum Cleaner - Bosch Turbobrush Instrucciones De Uso

en

Description of the appliance

1 Nozzle holder with accessory connection*
2 Nozzle holder without accessory connection*
3 Carpet button*
4 SelfClean button
5 Inspection window with turbine system
6 Brush roller release button
7 Brush roller guide rod
8 Brush roller
Starting up for the first time
1*
Fig.
a) Nozzle without accessory connection:
Place the Turbo brush on the suction pipe. To re-
lease the connection, turn the pipe slightly and pull
it out of the Turbo brush holder.
b) Nozzle with accessory connection:
Slide the telescopic pipe until it clicks into place
in the holder for the Turbo brush. To release the
connection, push the release collar and pull out the
telescopic pipe.
Vacuum brushing
!
Please note:
Only vacuum brush at full suction power, i.e. max.
power setting on the vacuum cleaner.
Cleaning carpets/carpeted floors
When cleaning carpets, the brush roller starts auto-
matically three seconds after the vacuum cleaner is
switched on.
When cleaning carpets, the turbine system works wi-
thout any braking. This creates the maximum suction
power for the nozzle.
Cleaning hard floors
The turbine system detects the type of flooring. When
changing from carpeted floors to hard floor, the tur-
bine system starts to brake down the rotation speed
and therefore reduces the noise level.
If you change flooring from hard floor to carpet the
turbine system doesn't brake anymore and have again
the maximum suction power.
2*
Fig Carpet button*
‡
Press the Carpet button when vacuuming long-pile
carpets.
This reduce a force of pushing nozzle and speed up
brush roller.
!
Please note:
The Carpet button can be pressed when cleaning
all types of flooring.
26
3
Fig. SelfClean button
‡
Press and hold the SeflClean button when nozzle
is on the hard floor to order to use the maximum
airflow and the minimum resistance for the brush
roller.
‡
The best results of cleaning brush roller are with
using function 3 times per 5 seconds. If it necessa-
ry please hold the button longer
!
Please note:
We recommend using the SelfClean function after
using the Turbo brush.
Maintenance
Before carrying out any maintenance work, switch
off the vacuum cleaner and pull out the mains plug.
Remove the Turbo brush from the suction/telescopic
pipe.
4
Fig.
‡
Use the release button to release the brush roller
and pull it sideways out of the Turbo brush.
5
Fig.
‡
Remove the dirt.
‡
When hairs gets stuck between the brush roller re-
lease button and the brush roller you can separate
them by pulling on the release button with some
force. Then you can clean the axis and put the parts
back together.
6
Fig.
‡
Push the brush roller in sideways along the guide
rod and into the Turbo brush, and lock it in place
using the release button.
!
Caution:
The Turbo brush must only be used with the brush
roller fitted.
Subject to technical modifications.
*depending on model