Machine Setup - Nilfisk GM 80 Manual De Usuario

the expense of the customer. Equipment shall not be returned without advance notice to,
and consent of the Nilfisk companies.
EXCEPT AS SPECIFICALLY SET FORTH HEREIN, THE NILFISK COMPANIES
MAKE NO WARRANTIES, EITHER EXPRESSED OR IMPLIED AS TO ANY
MATTER WHATSOEVER, INCLUDING WITHOUT LIMITATION ANY AND ALL
WARRANTIES OF MERCHANTABILITY, FITNESS FOR PURPOSE, OR OTHER
WARRANTIES, ALL OF WHICH ARE EXPRESSLY DISCLAIMED AND
EXCLUDED. NEITHER PARTY SHALL BE LIABLE TO THE OTHER FOR
SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES,
INCLUDING BUT NOT LIMITED TO LOSS OF PRODUCTION, LOSS OF TIME,
LOSS OF PROFITS OR OTHER SIMILAR INDIRECT LOSSES WHICH MIGHT
OCCUR AS A RESULT OF DEFECTS, PARTIAL OR TOTAL FAILURE OF THE
PRODUCT TO PERFORM AS SPECIFIED.
Correction of non-conformities or defects in the manner and for the period of time
provided above, shall constitute fulfillment of all liabilities of the Nilfisk companies to
the customer, whether based on contract, negligence or otherwise with respect to, or
arising out of such equipment. The remedies set forth herein are exclusive, and the
liability of the Nilfisk companies with respect to this sale or anything done in connection
therewith, whether in contract, in tort, under any warranty, or otherwise, shall not except
as expressly provided herein, exceed the price of the equipment or part on which such
liability is based.
The warranty does not cover repairs due to normal wear and tear, accident, neglect,
misuse or abuse, incorrect installation or use other than as described in the
instruction booklet. Breaks in hoses and cables are not covered. This warranty is
rendered void if the motor number plate is removed or defaced or if repairs are
made or attempted by persons not authorized by the Nilfisk companies.
Photo 1
Photo 1
Photo 1
Photo 1
Photo 2
Photo 2
Photo 2
MACHINE SET-UP:
Before turning on the motor: Install the microfilter (#616821-Felt,
#017230-AES Polycomposite, #017220-01-Gore-Tex®), the small
felt sock, on the bottom of the motor by sliding the filter over the
motor bottom, and covering as much of the bottom as the depth of
the filter will permit (photo 1). Be sure the filter's elastic collar
holds the filter snugly in place and is as high up on the motor
bottom as possible.
2. Next, mount the HEPA filter (#01710440) according to the
accompanying bulletin. Place the motor back in the cavity in the
top of the cleaner (photo 2). Fasten the motor head in place using
3