Emptying; Disposal; Maintenance/Filter Replacement - Nilfisk GM 80 Manual De Usuario

EMPTYING:

IF THIS VACUUM CLEANER IS USED TO COLLECT HAZARDOUS MATERIAL,
DO NOT ATTEMPT TO OPEN OR EMPTY ITS CONTENTS WITHOUT PERSONAL
PROTECTIVE CLOTHING AND RESPIRATORY PROTECTION.
Photo 6

DISPOSAL:

Depending on local regulations, and the composition of the material you have collected,
there can be a requirement for special handling and labeling of the filled and sealed
plastic bags. Consult your local Occupational Safety and Health Administration (OSHA)
and Environmental Protection Agency (EPA) official for details.
MAINTENANCE
Routine Maintenance:
To ensure maximum performance of your Nilfisk vacuum cleaner, be sure to check your
main filter regularly. Your filter may need to be shaken out to remove caked dust from
time to time.
Filter Replacement:
To ensure that your Nilfisk vacuum cleaner delivers the years of trouble-free operation
for which it was designed, it is necessary to check and replace filters regularly.
Photo 7
To empty the container and its contents, first turn off the motor.
To empty the container and its contents, first turn off the motor. Allow the cleaner to sit undisturbed for at least thirty (30)
Allow the cleaner to sit undisturbed for at least thirty (30) seconds. Then twist and release the container clips. Once the
seal is broken, turn on the motor again. This will prevent seconds. Then twist and release the container clips. Once the
ultrafine particles which are still suspended in the air inside the seal is broken, turn on the motor again. This will prevent
container from escaping into the work place. Lift off the ultrafine particles which are still suspended in the air inside the
container top. Remove the polyliner and paper bag within it container from escaping into the work place. Lift off the
(photo 6). Then seal off the polyliner with the paper bag inside container top. Remove the polyliner and paper bag within it
and install a new polyliner and paper bag according to step 2, (photo 6). Then seal off the polyliner with the paper bag inside
Machine Setup.
and install a new polyliner and paper bag according to step 2,
1. Main Filter: The large napped cotton bag which is semi-
permanently mounted inside the container will not require
frequent replacement. The main filter must be replaced when
the cleaner no longer develops powerful suction, yet bags are
not full and other filter components are not clogged. Extend
main filter service life by frequent changes of disposable
polyliners and paper bags (photo 7).
5