Programming Via Pc; Viewing The Device Settings; Downloading The Device Settings; Preliminary Operations - Bentel Security BGSM-120 Serie Manual De Usuario

 For proper function of this Communicator, use a 32 K SIM CARD (or higher).
For programming, the PC-Link cable (not supplied) must be connected to the Connector [9] of the Communicator and a COM
port on the PC (see Fig. 5); the BGSM-120/BGSM-100 Console application is also required. The PC-Link cable shown in Figure
5a, or the PC-Link cable shown in Figure 5b, can be used for the connection. Make sure you insert the PC-Link cable connector
in the right way. Once the PC-Link cable has been connected, set the computer COM port through the the Options->Serial
ports. Check the serial link and the serial port settings in case of communication problem, or use a different USB-RS232 adapter.
 To install and run the BGSM-120/BGSM-100 Console application, you will need to log on to the PC as the Administrator;
we also recommend to verify the firewall's options if problems arise while the application is being installed.

Viewing the Device Settings

To view the Communicator settings on the screen, use the Upload from board icon.

Downloading the Device Settings

Once programming has been completed (or an uploaded file containing existing data has been modified), download the data
into the Device, using the Download to board icon.

Preliminary operations

When the application starts, you will be presented with the Main window: if you use the mouse to click the menu option Untitled
#1 in the top left-hand part, two sections appear.
 The following sections may be found within the general parameters section:
Customer informations: this section can be used to set the Communicator series (BGSM-100 or BGSM-120),
or to recall and update the configuration corresponding to a particular client as follows:
1. Left-click on the application.
2. Enter or update the information relating to the customer and the system. Click to confirm.
Upload from board: If this icon is selected, the data programmed on the board is loaded onto the PC.
Download to board: If this icon is selected, the programmed data is sent to the board. Sending all of the device settings or
some "GPRS", "I/O" (BGSM-120 only) and "Options" (BGSM-100 only) pages to the device will reset the Alarm Communicator.
Factory defaults: Select this icon to restore the default settings. It should be noted that restoring the default settings
does not delete any voice messages recorded.
Board reset: If this icon is selected, the Communicator is reset.
5
3
2
RS-232
Solder
Side
Fig. 5 - Diagram of the PC-Link connection cable.
BGSM-100/120

PROGRAMMING VIA PC

1 4
Make sure you insert the PC-Link
cable connector in the right way
a
1 4
Make sure you insert the PC-Link
cable connector in the right way
G
b
17